Link-systems OmniLink - PLC Interface User Manual download pdf (Page 38)

June 5, 2000 Man ual Rev 1 .0 5.11

Section 5.7.19 Parameter 19 - Press Stroking Mode

Value:

Standard Numeric

Meaning:

Numeric code for the stroking mode of the press. The following codes apply:

1 = Inch

2 = Single Stroke

3 = Auto Single Stroke

4 = Continuous

5 = Timed Inch

6 = Setup/Stop Time Test

7 = Continuous on Demand

8 = Maintained Continuous

Section 5.7.20 Parameter 020 - Mode Select Key Flag

Value:

Standard Numeric

Meaning:

Non-Zero if Mode Select Key is active. The PLC can use this flag to give itself a mode select

capability without having to have a separate keyswitch.

Section 5.7.21 Parameter 021 - Motor Running Flag

Value:

Standard Numeric

Meaning:

Non-Zero if Motor is running.

Section 5.7.22 Parameter 022 - Clutch/Brake Flag

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 52 53

No comments

Link-systems OmniLink - PLC Interface User Manual Page 38